Already registered? Enter your email and password:First Visit?Create an account
Shop
Search Your Cart

12 Volt

For carburettor cars the standard fuel pump may not be able to maintain adequate fuel pressure at higher engine speeds, particularly with a tuned car.

Electric pumps can be fitted to the front or rear of the car, but ideally not higher than 70cm from the fuel tank bottom feed. Electric fuel pumps provide further benefits in alleviating problems associated with vapour lock and give constant fuel pressure even at high temperatures.

Where the original mechanical or electric fuel pump is not readily available these pumps are a cost-effective solution.

If converting from a manual pump be sure to fit a fuel prefilter before the pump - any dirt or grit larger than a grain of sand will instantly wreck an electric pump.

Fitment advice is available here
(Code: FPA)
£3.40
In Stock
Stub Pipe Union Set NylonSet of 6 black nylon stub pipe unions.
Suits fuel pumps, fuel filters, fuel lines.
1/8nptf to 6mm (quantity 2)
1/8nptf to 8mm (quantity 2)
1/8nptf to 10mm (quantity 2)
(Code: Punion)
£11.00
Awaiting stock.
 Fuel Pump BracketBillet alloy fuel pump mounting bracket
Suits all 60mm diameter pumps (Bosh 044, Facet, Walbro, Sytec etc) and 60mm filters
Complete with rubber anti-slip inserts and socket cap bolts.
Mount ID 59mm - 65mm

(Code: FPB60MM)
£22.80
In Stock
Billet Aluminium Fuel Pump Blanking PlateUseful to cover & seal the hole in the engine block when converting from an electric pump
Beautifully CNC'd from lightweight billet alloy
Measures 67.1mm high by 65.2mm wide by 11mm thick. Two 9.7mm mounting holes with 44.5mm hole centres
Please examine your application to check fitment - but known fitting applications include: classic Triumph OHV engines (eg Spitfire, Herald, Vitesse, GT6, TR6). Chevy small & big blocks, Chrysler small & big blocks, Ford small blocks.
Weighs 79 grams
Supplied complete with gasket
(Code: BFBOP)
£22.80
In Stock
Fuel Pump Inertia Cut Off SwitchSuits our electric fuel pump as well as any pumps with a rating under 10amps (pumps rated above 10 amp will need a relay incorporated).
Usually installed in the +12 volt feed wire to an electric fuel pump, connected to the closed position contacts (NC). Should be securely mounted with rubber diaphragm mounted upwards

In the event of a crash or hard shock, the switch contacts will open, shutting down the fuel pump and if desired switching on a warning light telling you that the switch has been activated.To reset the switch just press the rubber diaphragm.

(Code: WQT100030)
£39.12
In Stock
RatSport Cylindrical PumpDesigned as an electrical replacement conversion for classic cars with manual fuel pumps
Also suitable replacement for Lucas pumps part numbers FDB790, FDB787 and FDB788
12volt, negative earth, current draw 4.5amp
Male push adapter fitted to wiring (you may want to remove this and use alternative electrical terminals at your convenience)
Pressure (Psi): 3-4.5
Flow in Gallons/Hour: 20-28
Push on adapters 5/16" (8mm), barbed for a secure connection
Dimensions: 145mm long, 54mm diameter, weighs 405 gram
Suitable for standard and fast-road vehicles up to 120BHP
Suitable for modern ethanol-added fuels (E10-E85)
Quiet operation

Suits non-injected vehicles only


(Code: RFPFDB790)
£47.76
In Stock
Bosch Type Fuel PumpBosch type 0-580-254-044 (Bosch 044 equivilent), Walbro type 255LPH
Can be used in sequence if desired with in-tank Walbro or Bosch 040 pump
12volt, negative earth
Pressure (Psi): 43.5 to 72.5 (3-5 bar)
Max Flow in Litres/Hour: 300
Thread Size: Inlet M18 x 1.5 female, outlet M12 x 1.5 female
60mm diameter, 195mm long, 1030 grams
Suitable for standard and competition vehicles up to 550BHP
Suitable for modern ethanol-added fuels (E10-E85)
Quiet operation

Suits injected vehicles only
(Code: FPBT0580254044)
£54.60
In Stock
Facet Type Cylindrical Fuel Pump12volt, negative earth
Pressure (Psi): 4.0-6.0
Flow in US Gallons/Hour: 30
Thread Size: 1/8nptf
60mm diameter, 151mm long
Suitable for standard and competition vehicles up to 150BHP
Suitable for modern ethanol-added fuels (E10-E85)
Quiet operation

Suits non-injected vehicles only
(Code: FFPRTW506C)
£64.00
In Stock
Lucas Cylindrical PumpLucas part number FDB790, direct replacement for FDB787 and FDB788
12volt, negative earth, current draw 5amp
Pressure (Psi): 2.5-4.5
Flow in Gallons/Hour: 20-28
Thread Size: 1/8npt (includes push on adapters 5/16" 8mm)
Dimensions: 172mm long, 54mm diameter
Suitable for standard and fast-road vehicles up to 120BHP
Suitable for modern ethanol-added fuels (E10-E85)
Quiet operation

Suits non-injected vehicles only

(Code: LFPFDB790)
£72.65
Supplied to order
Available in 3 days
Facet Cube Pump12volt, negative earth
Pressure (Psi): 4.5-7.0
Flow in US Gallons/Hour: 32
Thread Size: 1/8nptf
Suitable for standard and fast-road vehicles up to 150BHP
Suitable for modern ethanol-added fuels (E10-E85)

Please be advised that these fuel pumps are noisy in operation.

Suits non-injected vehicles only

(Code: FFPSS502)
£136.78
Supplied to order
Available in 3 days
Facet Cylindrical "Red Top" Fuel Pump12volt, negative earth
Pressure (Psi): 6.0-8.0
Flow in US Gallons/Hour: 40
Thread Size: 1/4nptf
60mm diameter, 150mm long
Suitable for standard and competition vehicles up to 280BHP
Suitable for modern ethanol-added fuels (E10-E85)
Quiet operation

Suits non-injected vehicles only
(Code: FFPRTW506)
 
Follow @RatSport